Touch-Less Snow Foam - 1000ml | 1000ml

Bilthamber Touch-Less is the new eco-friendly pre-wash suitable for foam lances and hand foamers. You can even use the product in a spray bottle or pump dispenser.

With an average PIR (Panel Impact Ratio) of 0.5 - 2%, this sugar-based biodegradable formula is highly effective in contactless cleaning of car paint. Unlike other petroleum-based cleaners, Touch-Less is very easy to rinse off without leaving any residue, making bucket washing afterward simpler and faster. Additionally, Touch-Less contains corrosion inhibitors. It is free from phosphates, solvents, NTA, and caustic soda.

Product number:	BH-TOUCHLESS1L

H318: Causes serious eye damage.

Touch-Less can be applied using a foam lance, hand foamer, or spray bottle.

The minimum recommended PIR (Panel Impact Ratio) is 0.5%, up to a maximum of 2% for very dirty vehicles. The dilution in a hand foamer or spray bottle is easy to determine. For foam lances, it is more challenging because it depends on the water flow rate of the pressure washer.

The following steps need to be done only once; don’t forget to note the ratio on the packaging for future use.

Fill the mixing bottle with tap water to the maximum level. Set the foam lance, or if you’re using the pressure washer’s reservoir, to the maximum product flow.
Take an empty large bucket and spray with the foam lance connected into the bucket until the entire mixing bottle is empty and stop immediately. If the bottle is not empty and the bucket is full, halve the amount of water in the mixing bottle and start again. All the following numbers should then also be halved.
The following calculation provides a PIR of 2%. Measure the total amount of liters in the bucket after the mixing bottle is empty. Multiply this number by 0.02.
The resulting number is the amount of product needed for the content of your mixing bottle.
Mix the bottle with the desired amount of product and water.
Foam the car and let it dwell for 1-5 minutes. Never let the product dry. Then rinse off with high pressure.

Example Calculation with a Pressure Washer and a Monello Lancia Foam Lance with a 1000 ml Mixing Bottle:

Fill the mixing bottle completely with tap water (1000 ml).
Attach the foam lance to the pressure washer and turn the knob on top fully closed (maximum foam setting).
Spray into an empty large bucket until the 1000 ml mixing bottle is (almost) empty.
Once the bottle is almost empty, the bucket is filled with 13 liters of water.
The amount of product needed is 13 x 0.02 = 260 ml, and the rest with water.
You do not need to use all the mixture at once; the mixture can be stored. You can also use half by mixing 130 ml of product with 240 ml of water. With one liter of mixture, you can do about 8-10 washes, depending on your pressure washer and water pressure.